12V OEM Push Button Switch For Toyota Switch Replacement Face Size 39mm x 21mm
Black hard surface rocker, Laser etched Legend
Led: Orange Led
Rated at 3Amp 12V
High quality single pole single throw ON-OFF push switch
Face surface size: 39 mm x 21 mm ( 1.54" x 0.83"), Uses the original mounting hole of the vehicle
Switch cutout required for the other accessories is about 17mm x 36 mm ( 0.67" x 1.42" ),
Wateproof Rating: IP65
Upper light is ON when the switch is pressed IN; Lower light can be wired to separate dash light circuit
These switches are an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
Package Include: 1 x switch, 1 x set of cable
 This Switch Suits the following models : Additional vehicles that are not listed may be suitable for these switches. Please Check Sizing
For Toyota Prado 120 Series 2003 - 2009
For Toyota Landcruiser 100 Series 1998 - 2007
For Toyota Landcruiser 75, 76, 78, &79 Series New Model
For Toyota FJ Cruiser 2007 - 2015
For Toyota Hilux KUN26R, GGN15R, GGN25R 2005 - Current
For Toyota Tacoma 2005-2011
For Toyota Tacoma 2012-2015 ( Left Side ONLY )
For Toyota Fortuner 2005-2014
For Toyota Highlander 2001-2007
For Toyota Tundra 2005-2007 ( Center Console if equipped)
For Toyota 4Runner 2003-2009
The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.