Advantage of photochromic film :
Photochromic window film become darken in response to UV light in less than one minute, and continue to be darker a little over the next ten minutes. This film begin high VLT in the absence of UV light, and will be noticeably lighter within two minutes, mostly clear within five minutes, and fully back to their non-exposed state in about fifteen minutes.
This film will prevents sunlight from achieving true sunglass darkness in very hot weather.
 
Film Size:
50cmx3m for Left and right side windows;
76cmx152cm for Rear windshield;
100cmx152/200cm for Front windshield;
 
Package includes:
1pcs X Window Film
 
Installation steps(Suggested installation inside):
1. Clean the inner and outer surfaces of the car window.
2. Cut the film into a suitable size for the glass, which can be slightly larger because it will shrink slightly after being blown by the hot air blower;
3. Spray some water on the surface of the glass and torn protective film to reduce the viscosity of the adhesive layer and adjust the position of the orientation film;
4. The car window glass has a certain curvature and can be baked with a hot air blower.
5. Spray some cleaning solution on the inner glass and then spray it onto the torn protective film surface. After aligning the position, it can be pasted;
During the pasting process, there may be some bubbles and water. Use a scraper to remove bubbles and moisture;
7. Finally, check for bubbles, wrinkles, scratches, etc. Between car film and glass. If there is no problem, wipe off the water on the edge of the glass with a towel.