This is a high quality 12V 3A dual button push switch. It is one of the MUST HAVES for your vehicle modefications, especially when the space is limited. It has a face surface size of 33mm x 22.5 mm and uses the original mounting hole of the vehicle.
Black hard surface
Laser etched by using modern high-tech laser engraving equipment to ensure long image life
Rated at 3Amp 12V
Most switches are single pole single throw ON-OFF maintained switch. When you press it works and press again it stops working. Momentary switch goes to off position when you release your finger
Led Light:  OFF (White);  ON (Orange)
Face surface size: about 33 mm x 22.5 mm ( 1.28"x 0.87" ) the original mounting hole of the vehicle
These switches are an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's
The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay
This Switch Suits the following models : Additional vehicles that are not listed may be suitable for these switches. Please Check Sizing
For Toyota Prado 150 Series 2010 - Current
For Toyota Prado 200 Series 2008 - Current
For Toyota Landcruiser 200 Series 2008 - Current
For Toyota RAV4 2006 - 2019
For Toyota Hilux GUN Series 09/2015 - Current
For Toyota HiAce 2014 - Current
For 4 Runner 2008-2020
86 ( Subaru BRZ/Scion FR-S)  2012-2020
Camry 2011-2014
Carolla  2006-2013
FJ Cruiser ( roof console only) 2011-2016
Fortuner 2015-Current
Kluger 2008-2019
Landcruiser 79 Series ( plastic dash) Right side of steering wheel  2021-Current
Tundra 2007-2014
Suzuki Jimny JB64W JB74W 2018-Current