Car Fuel Injector Tester Work With Fuel Pressure Tester Gasoline Engine 4 Pulse Modes 4 Test Leads High Power DIY Detector
The tester can help diagnose injector problems, you can use it to test each injector individually to help identify stuck, leaking or burnt-out conditions. It uses 12V vehicle battery for power. It has 4 pulse mode, (1) Short, (2) Medium , (3) Long , and (4) Continuous mode that helps identify good or bad injector. The mode lock features ensures test condition uniformity. It can work with any fuel pressure tester. (Please NOTE: Gasoline car only, NOT the diesel engine.)
Features:
1.【Powerful Injector Tester】You can use it to test each injector individually to help identifing stuck, leaking or burnt-out conditions. It works with engine off and pulse timer may be used with fuel pressure gauge.
2.【4 Long Test Leads】This injector tester with 100cm/ 39.37 inches test leads can work with any fuel pressure tester. You can test 2 injetectors at the same which save time.Please NOTE: Gasoline car only, NOT the diesel engine
3.【4 Pulse Modes】Large LED display with 4 pulse modes- Short/ Medium/ Long/ Continuous modes help to identify good or bad injector.
4.【Short Circuit Protection Design】The device is built-in short circuit protection function which can judge the fuel injector coil is short circuit or not.
5.【2 Drive Modes】The device is built-in high power and low power drive modes,you can select the modes as your needs.
4 Pulse Modes：
Mode 1: the tester will output 1 pulse, whose pulse width is about 250ms.
Mode 2: the tester will output 50 pulses, every pulse’s pulse width is about 7ms.
Mode 3: the tester will output 100 pulses, every pulse’s pulse width is about 3.5ms.
Mode 4: the tester will output continuously at the rate of 50 pulses per about 1450ms, every pulse’s pulse width is about 7ms.
At any time, you can press the PULSE key again to stop outputting pluse.
Widely Application：
Compatible with Bosch, Denso, Delphi, Siemens, Magnetic Marell fuel injectors( except Cylinder Direct-Injection Nozzle )
4 Long Test Leads:
This injector tester with 100cm/ 39.37 inches test leads can work with any fuel pressure tester. You can test 2 injetectors at the same which save time
Operation Instruction:
1. Turn off the vehicle's engine.
2. Connect the black clip to the negative terminal of the vehicle battery, connect the red clip to the positive terminal of the battery.
3. Locate the fuel injector which you want to test, then remove the electrical cable from this injector and connect the tester’s two pulse output terminals to the electrical connector of this injector.
4. Press the MODE SET key to select the desired pulse mode, the display shows the current pulse mode.
5. After you have selected the desired pulse mode, press the PULSE key.
The tester outputs pulse(s) to the injector under test, the pulse signal indicator will light as indication.
PLEASE NOTE: Gasoline engine only, NOT the diesel engine.
Specification:
Power Supply:12V vehicle battery
Operation Environment:0-40°C, relative humidity≤80%
Storage Environment:-10°C ~50°C, relative humidity≤85%
Test Cable Length: 100cm/ 39.7inches
Material: ABS
Weight: 300g;
Package includes:
1 x injector tester
4 x fuel cleaning injector nozzle adapters
1 x English manual
1 x carrying bag