Note:This product does not contain glue gun and glue stick, if you need, need to buy another.
Packing lncluded:
【Short Puller Kit】
1x Short T Bar
18x Short Blue Tabs (6 Sizes)
【44cm Puller Kit】
20x Short Blue Tabs (5 Sizes)
1x 44cm T Bar Tools
【50cm Puller Kit】
20x Short Blue Tabs (5 Sizes)
1x 50cm T Bar Tools
【6 Pcs】
4 * Long Blue Tabs (2 Sizes)
2 * Holder  (2 Sizes)
Description:
This Paintless Dent Repair T-Bar puller is a lightweight glue tab pulling tool, meant to be used when repairing pressure dents and any dent that isn't sharp or creased.
The tension puller works well with a tap down hammer when pulling large dents.
It's very easy to control, everyone can removal the dent easily by yourself.
Description:
This Paintless Dent Repair T-Bar puller is a lightweight glue tab pulling tool, meant to be used when repairing pressure dents and any dent that isn't sharp or creased.
The tension puller works well with a tap down hammer when pulling large dents.
It's very easy to control, everyone can removal the dent easily by yourself.
How to use: 
1.Clean the dent with a clean wet cloth;
2.Mount the glue stick into the glue gun,pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes;
3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the
drawing gasket is, the larger the drawing force is);
4. Pull the trigger and apply the drawing gasket with extruded glue;
5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter);
6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;
7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen;
8. Clean the repaired place with a clean wet cloth.