Features:
Self-healing,Stretchable, Scratch Resistan Item.
Hot repair Easy Removal with No Residual.
Suitable for Any Headlights, Fog Lights, Side Marker lights or Body paint surface etc(DIY)
Name:Car headlight film
Material :TPU
Size:Width 30cm/Length 1/1.5/2/3M
(The appropriate size for general car headlights is 1.5 meters. If your car headlight size long, please choose 2 meters.)
Color: Clear/light black/light gray/blackened/drak black
(Due to the difference between different monitors, the pictures may not reflect the actual color of the item)
Easy to remove: our film is easy to be cleared and will not leave the glue in your car. Film can be heated properly by hair dryer, back adhesive will be soft to removed
How to Install:Clean the dust of the headlights and spray water, then tear off the two layers of the sticker, spray water (purified water or with water and neutral shampoo) on the adhesive, to facilitate adjustment when pasting, and heat with a hot air gun during the installation process so that the film can be Stretch and stick to the lights, and use a scraper to remove water and air bubbles to make the film more fitasy to be cleared and will not leave the glue in your car. Film can be heated properly by hair dryer, back adhesive will be soft to removed.
Important Reminder:
About TPU Soft Film:
1. The TPU soft film is washable and can be installed multiple times.
2. Spray water or detergent water on the film and screen to help squeeze out bubbles.
3. The soft film can be installed many times without damage. If installed failed, just removed it and installed it again until successful.
4.TPU is one kind of rubber and it is elastic, if it is folded, the crease will disappear when it stick on the car. Unless there is a hole, the folded will not affect the installation.The screen must be cleaned before installation and ensure that there is no dust.
If you are not good at DIY, it is best to ask local professional installers for help. But if you don't find it troublesome, you can install it yourself, but there may be a lot of bubbles after installation, you need to try repeatedly until the bubbles are removed and the installation is successful. We will not accept the refund for manmade mistakes or due to wrong installation.
Installation Tip :
Step 1: Prepare a spray bottle (water and 1 drop of shower gel), a rag and a scraper, and thoroughly clean the application area.
Step 2: Remove the film and spray a certain amount of water on the sticky side.
Step 3: First align the holes, which will help align the entire film.
Step 4: Use a scraper to scrape off water and bubbles from the center to the corner. Cut off excess film.
Step 5: Use a hot air gun, hair dryer, or lighter to flatten and secure uneven areas.